 |
|
 |
 |
 |
 |
 |
    |
 |
 |
 |
 |
NoSpray® Protection System
NoSpray® Protection System is a type approved aluminum/glass cloth jacketing system designed to prevent the flammable spray of hot oil which can come in contact with hot surfaces thus causing fires in vessel engine rooms.
NoSpray® is available in tape or sheet format and is coated on one side with a silicone adhesive for ease of installation and superior adhesion.
Meets SOLAS Regulation II - 2/15.2.11
Applications
For Protection of Insulated High Temperature Surfaces
NoSpray can be used as a protective shield on insulated hot surfaces which are in close proximity to potential oil spray in the engine room.
The areas of fire risk listed on the left should be protected from the sources of ignition listed on the right:
| – | Fuel oil injection pipes, fuel oil service pipes, fuel oil valve cooling oil pipes attached to diesel engines |
| – | Lube oil service pipes and hydraulic oil pipes attached to diesel engines |
| – | Flammable oil pipes |
| – | Flammable oil pump and strainer |
| – | Fuel oil heater |
| – | Lube oil heater and cooler |
| – | Fuel oil purifier - Lube oil purifier |
| – | Fuel oil burning unit for boiler, thermal oil heater, inert gas generator and incinerator |
| – | Level gauge, fittings and oil tray of flammable oil tank |
| – | exhaust gas pipe |
| – | steam pipe |
| – | turbo charger |
| – | electrical equipment |
| – | boiler, thermal oil heater, incinerator |
| – | welding spatter, cigarettes, etc. |
|
|
|
|
  |
|
|
|
|
| 1.) | Be sure that all surfaces to be protected are cleaned
and free of oil. |
| 2.) | Select the NoSpray format applicable to your installation,
and, with adhesive film in place, cut with scissors as follows: |
| For Pipes and Joints: Use NoSpray Tape and allow overlap of 50% each turn. |
|
| For Valves, Flanges, and other irregular shaped
equipment: Use NoSpray Sheet and cut a to size as follows: |
|
| Length: |
to wrap 2 layers thick around surface to be protected. |
| Width: | to be enough to completely cover bolts
and overlap onto connecting pipe
at least 100 mm (4”). |
|
Special care must be taken where a device such as a valve
is connected to the pipe being wrapped. In this case,
the NoSpray Tape must be wrapped around the attached device
as well as the pipe. When using NoSpray Sheet, apply NoSpray Tape on top of the sheet overlapping 50% to secure the NoSpray Sheet. |
| 3.) | Important Tip When applying NoSpray Tape, be sure to wrap loosely to allow free flow of oil leak. DO NOT WRAP TIGHTLY. |
| 4.) | When applying NoSpray Sheet or Tape, peel off the
adhesive film a little at a time so as not to contaminate adhesive
surface with dust or oil prior to application. Wrap snugly (not
too tight) around pipe or joint in the likely direction of an
oil spray leak. NoSpray Sheet or Tape should be continued to
a point where any potential leaks would occur safely away from
hot surfaces that could cause combustion. |
| 5.) | For maintenance and repairs, NoSpray can be removed
by cutting with a knife, or tearing with pliers. NoSpray cannot
be reused once removed. |
Important Note
Periodic inspections must be carried out in areas applied with NoSpray Tape. Unravelling, curling, loosening or cracking indicates tape on the applied area must be replaced.
Application Instructions
 |
 |
