Copyright © RTW Engineering 2004 / 2007 Portions copyright Insulmastic.  
 
Nospray Shield

NoSpray® Shields

This product is designed to contain the spray of hazardous liquids in vessel engine rooms, a cause of dangerous fires and loss of life and property.

NoSpray® Shields are manufactured in multiple layers from a silicone rubber applied on a silica fibre fabric, specially formulated to withstand high temperatures and pressures, and an aluminum foil lining, which creates a corrosion resistant barrier for long lasting protection.

NoSpray® Shields are available in various widths which can be cut to size for use on flanges, valves, fittings, or any irregular shaped surface which can leak hazardous liquids. NoSpray® Shields encapsulate the protected surface and are easily installed using our drawstring system. Removable, reusable and extremely durable, NoSpray® Shields provide a consistent, clean look in vessel engine rooms.

Meets SOLAS Regulation II - 2/15.2.11

Installation Instructions

NoSpray Shields   1.) Measure the outside diameter of the flange and cut the NoSpray Shield to a length of 130%.
 
  2.) Cut a small hole about 1” (25mm) from each end of the shield on the pocket.
 
  3.) Centre the shield on the flange and wrap snugly, overlapping the ends.
 
  4.) Thread a lacing wire through each of the two cut holes and pull the lacing wire through the pockets.
 
5.)   Draw together and fold under the cut edge of Shield for a neat finish.
 
6.)   When pulled together snugly, secure with pliers and cut off excess wire.
 

 

Member of